M K - 3 0 0 3 M A N TOSHIBA Native| Translation ------+-----+-----+----- Form 2.5"/SUPERSLIMLINE Cylinders | | | Capacity form/unform 3080/ MB Heads | | | Seek time / track 13.0/ ms Sector/track | | | Controller IDE / ATA3 Precompensation Cache/Buffer 128 KB Landing Zone Data transfer rate MB/S int Bytes/Sector 512 16.600 MB/S ext PIO4 Recording method operating | non-operating -------------+-------------- Supply voltage Temperature *C 5 55 | Power: sleep W Humidity % 8 80 | standby W Altitude km | idle W Shock g | seek W Rotation RPM read/write W Acoustic dBA 35 spin-up W ECC Bit MTBF h 300000 Warranty Month 36 Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** TOSHIBA MK3003MAN HDD-2619 JUMPER SETTING +-+ 43-------------------------------------------1+C+A+ |* * * * * * * * * * * * * * * * * * * * * * *|*|*| ---+* * * * * * * * * * * * * * * * * * * * * *|*|*+----- 44-----------------------+-------------------2+D+B+ | +-+ Polarity Key ********************************************************************** J U M P E R S ********************************************************************** TOSHIBA MK3003MAN HDD-2619 JUMPER SETTING Jumper Setting ============== Master/Slave Configuration -------------------------- Drive address is set by the optional jumper of the interface connector. If jumper is open, drive is set to be Master. If jumper plug is inserted into position C - D, drive is set to be Slave. If jumper plug is set with position B - D and P28 (CSEL) signal is low, drive is Master drive. If jumper plug is set with position B - D and P28 (CSEL) signal is high, drive is Slave drive. In case of using 2 Drives one must set as Master and the other is set to Slave. In case of using single Drive, drive must be set as Master. PROHIBIT!! A-B JUMPER A-C JUMPER