D T C A - 2 4 0 8 0 T R A V E L 4 G T IBM Native| Translation ------+-----+-----+----- Form 3.5"/SLIMLINE Cylinders | | | Capacity form/unform 4080/ MB Heads | | | Seek time / track 13.0/ ms Sector/track | | | Controller IDE / ATA3 FAST Precompensation Cache/Buffer 512 KB Landing Zone Data transfer rate 9.000 MB/S int Bytes/Sector 512 33.300 MB/S ext Recording method operating | non-operating -------------+-------------- Supply voltage Temperature *C | Power: sleep W Humidity % | standby W Altitude km | idle W Shock g 100 | 600 seek W Rotation RPM 4000 read/write W Acoustic dBA spin-up W ECC Bit MTBF h Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** IBM DTCA-23240/24090 TRAVELSTAR 4GT +--------------------------------------+ | | | | | | +--------Interface-------------49------+ | **********************1 **47 Jumper | *************x********* **48 | +------44----------------------50------+ + + Pin position 20 is left blank for secure connector insertion. ********************************************************************** J U M P E R S ********************************************************************** IBM DTCA-23240/24090 JUMPER SEWTTING Jumper Setting ============== Drive Address Setting --------------------- A jumper is available at the interface connector to determine the drive address. Using Cable Selection, the drive address depends on the condition of pin 28 of the AT interface cable. In the case when pin 28 is ground or low, the drive is a Master. If pin 28 is open or high level, the drive is a Slave.