Data bus:	16-bit, ISA
Size:	Half-length, full-height card
Hard drive supported:	Two IDE (AT) Interface drives
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS
Function	Location
34-pin control cable connector - (reserved for future use)	J1
34-pin control cable connector - floppy drive	J2
4-pin connector - Drive active LED	J3
40-pin IDE(AT) Interface connector	J6

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Hard drive Interrupt Request IRQ14 enabled	W21	closed
	Hard drive Interrupt Request IRQ14 disabled	W21	open

HARD DRIVE PORT ADDRESS
Function		SW1/jumper 1	SW1/jumper 2
»	Hard drive port address is 1F0-1F7h	closed	open
	Hard drive port address is 170-177h	open	closed

FLOPPY DRIVE PORT ADDRESS
Function		SW1/jumper 1	SW1/jumper 2
»	Floppy drive port address is 3F0-3F7h	closed	open
	Floppy drive port address is 370-377h	open	closed

MISCELLANEOUS TECHNICAL NOTES

Jumpers J4 (Drive-type 300Kb/sec) is factory configured to pins 2 & 3 closed - do not alter J5 (Pump/Precomp) is factory configured to pins 1 & 2 closed - do not alter.