Data bus:	32-bit PCI
Size:	Half-length, half-height card
Hard drive supported:	Four IDE(AT) or EIDE interface drives
Floppy drives supported:	None

CONNECTIONS
Function	Location
10-pin DTC-1415 ISA B Interrupt adapter connector	J1
4-pin connector - drive active LED	J2
40-pin connector - primary IDE(AT) interface	J3
40-pin connector - secondary IDE(AT) interface	J4
Note: Connector J1 is intended for use in systems that do not support redirected PCI interrupts.

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Primary port INTA redirect to IRQ14	W1/pins 1 & 3	closed
	Primary port INTB redirect to IRQ14	W1/pins 2 & 4	closed
	Primary port INTC redirect to IRQ14	W1/pins 3 & 5	closed
	Primary port INTD redirect to IRQ14	W1/pins 4 & 6	closed
	Secondary port INTA redirect to IRQ15, IRQ12 or IRQ11	W2/pins 1 & 3	closed
	Secondary port INTB redirect to IRQ15, IRQ12 or IRQ11	W2/pins 2 & 4	closed
	Secondary port INTC redirect to IRQ15, IRQ12 or IRQ11	W2/pins 3 & 5	closed
	Secondary port INTD redirect to IRQ15, IRQ12 or IRQ11	W2/pins 4 & 6	closed
»	Fixed IDE address at power-up (1F0-1F7h)	W3	closed
	Relocatable IDE address at power-up	W3	open
»	IDE decode state disabled after reset	W4	closed
	IDE decode state enabled after reset	W4	open