M K - 1 0 0 2 M A V H D D - 2 7 3 1 TOSHIBA Native| Translation ------+-----+-----+----- Form 2.5"/SUPERSLIMLINE Cylinders 3560| 2100| | Capacity form/unform 1085/ MB Heads | 16| | Seek time / track 13.0/ 3.0 ms Sector/track | 63| | Controller IDE / ATA3 EMBEDDED Precompensation Cache/Buffer 128 KB Landing Zone Data transfer rate 6.900 MB/S int Bytes/Sector 512 16.600 MB/S ext PIO4 Recording method operating | non-operating -------------+-------------- Supply voltage 5 V Temperature *C 5 55 | -20 60 Power: sleep 0.1 W Humidity % | standby 0.3 W Altitude km | idle W Shock g 100 | 200 seek 2.5 W Rotation RPM 4635 read/write 2.5 W Acoustic dBA 33 spin-up W ECC Bit MTBF h 300000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** J U M P E R S ********************************************************************** TOSHIBA MK1002MAV JUMPER SETTING Jumper Setting ============== Master/Slave ------------ Toshiba's 2,5" hard disk drives can be configured as a master or slave. Master configuration is used for all single drive applications, Master and Slave configuration (only one of each per I/O port) is used for two drive applications. Master configuration is obtained by setting Jumper J2 open (no Jumper). Slave configuration is obtained by installing a jumper on J2. If Pin #28 = 0, drive = master. If Pin #28 = 1, drive = slave. Jumper J1 is reserved for factory use only.