D 1 6 3 2 NEC Native| Translation ------+-----+-----+----- Form PCMCIA TYPE III Cylinders | 977| | Capacity form/unform 85/ MB Heads 4| 10| | Seek time / track 16.0/ ms Sector/track | 17| | Controller PCMCIA / ATA Precompensation Cache/Buffer 32 KB Landing Zone Data transfer rate 4.500 MB/S int Bytes/Sector 512 MB/S ext Recording method operating | non-operating -------------+-------------- Supply voltage 5 V Temperature *C 5 55 | -40 60 Power: sleep W Humidity % 8 80 | 8 80 standby W Altitude km | idle 0.6 W Shock g 20 | 200 seek 1.5 W Rotation RPM 5400 read/write 1.5 W Acoustic dBA spin-up 3.0 W ECC Bit MTBF h 100000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** J U M P E R S ********************************************************************** NEC IDE/AT JUMPER CONFIGURATION Jumper Setting ============== Jumper Konfiguration I1 ----------------------- +--------------+---------------+-------------+ |Single Drive | Master Drive | Slave Drive | +--------------+---------------+-------------+ |JP12 OPEN | JP12 CLOSED | JP12 CLOSED | |JP13 OPEN | JP13 OPEN | JP13 CLOSED | +--------------+---------------+-------------+ Jumper Konfiguration I2 ----------------------- +--------------+---------------+-------------+ |Single Drive | Master Drive | Slave Drive | +--------------+---------------+-------------+ |JP12 CLOSED | JP12 OPEN | JP12 OPEN | |JP13 CLOSED | JP13 CLOSED | JP13 OPEN | +--------------+---------------+-------------+ Jumper Konfiguration I3 ----------------------- +--------------+---------------+-------------+ |Single Drive | Master Drive | Slave Drive | +--------------+---------------+-------------+ |MST CLOSED | MST CLOSED | MST OPEN | |SLV OPEN | SLV OPEN | SLV CLOSED | |TRS CLOSED | TRS CLOSED | TRS CLOSED | +--------------+---------------+-------------+ Jumper Konfiguration I4 ----------------------- +--------+ON |x x x x | Single Drive +1-2-3-4-+OFF +--------+ON |x x x x | Master Drive +1-2-3-4-+OFF +--------+ON |x x x x | Slave Drive +1-2-3-4-+OFF +--------+ON |x x x x | Or you use the Cable Select signal, Master/Slave is +1-2-3-4-+OFF always the same (see below). Jumper Konfiguration I5 ----------------------- +-----------------+----------------+----------------+ |Single Drive |Master Drive |Slave Drive | +-----------------+----------------+----------------+ |Pin 47/48 CLOSED |Pin 47/48 CLOSED| Pin 47/48 OPEN | +-----------------+----------------+----------------+