MYLEX CORPORATION

DAC960P, DAC960PD, DAC960PD-ULTRA

Processor

RISC

Maximum Onboard Memory

4/8/16/32MB (n x 36) optional DRAM

4/8MB (n x 36) optional EDRAM

Data Bus

32-bit PCI

Card Size

Full-length, full-height card

Hard Drives supported

Up to 45 Ultra-SCSI devices (DAC960PD-Ultra)

Up to 45 Fast SCSI-2/Wide SCSI devices (DAC960P/PD)

Floppy Drives supported

None

RAID Levels supported

0,1,5, and 0+1

CONNECTIONS

Function

Location

Function

Location

26-pin connector - AEMI port

J1

68-pin SCSI connector - channel 2 internal

J5

10-pin connector - battery backup (optional)

J2

6-pin connector - bus/drive active LED

J6

68-pin SCSI connector - channel 0 internal

J3

68-pin SCSI connector - channel 0 external

J11

68-pin SCSI connector - channel 1 internal

J4

68-pin SCSI connector - channel 1 external

J14

Note: AEMI is the acronym for Array Enclosure Management Interface.

USER CONFIGURABLE SETTINGS

Function

Label

Position

»

Factory configured - do not alter

J7

Unidentified

»

SCSI channel 0 termination enabled

J9

Closed

 

SCSI channel 0 termination disabled

J9

Open

»

SCSI channel 2 termination enabled

J10

Closed

 

SCSI channel 2 termination disabled

J10

Open

»

SCSI channel 1 termination enabled

J12

Closed

 

SCSI channel 1 termination disabled

J12

Open

 

Enable termination on a SCSI channel if the controller is installed at one end of the channel. This setting terminates the channel and powers the SCSI TERMPWR signal.

Disable termination on a SCSI channel if the controller is not at the end of the channel (i.e., both external and internal devices exist on the same channel).

DIAGNOSTIC LED(S)

LED

Status

Condition

J6/pins 1 & 2

On

SCSI is active

(Data is being transmitted/received across SCSI channels)

J6/pins 1 & 2

Off

No SCSI activity

J6/pins 3 & 4

On

PCI is active

(Data is being transmitted/received to/from host)

J6/pins 3 & 4

Off

No PCI activity

J6/pins 5 & 6

On

Write is pending

(Cache holds data that needs to be written to disk)

J6/pins 5 & 6

Off

No write is pending

Note: If the system loses power or is reset while J6/pins 5 & 6 are on, the data in cache memory will be

lost. Installing optional cache battery backup module J2 will avoid data loss.